混凝土中的声发射波速特性及其在源定位中的应用*

利用声发射技术监测受载混凝土裂缝发展特征的首要任务是对声发射源的准确定位。为了解混凝土中声发射波速特性,提高声发射源定位精度,该文开展了一系列室内试验,构建了考虑衰减现象的声发射波速修正模型,优化建立了基于修正波速的区域穷举定位法。结果表明:水灰比越小,基准波速越大,波速随距离的衰减越大。骨料粒径越大,基准波速越大,波速随距离的衰减越大。直线距离小于500 mm时,可采用对数函数描述声发射波速与距离的定量关系,以此构建的波速修正模型满足工程精度要求。采用修正波速的区域穷举定位法对单轴压缩试验产生的裂缝进行定位时,定位点比时差定位法更接近裂缝实际位置,有效提高了定位精度。     

OFDM水声通信CS限幅失真补偿与LS信道估计优化算法*

正交频分复用技术应用于水声通信系统时,会引起较高的峰均比,当采用限幅法对峰均比进行抑制时,会产生非线性失真。另外,系统采用最小二乘法进行信道估计受噪声的影响较大。针对以上问题,提出了一种基于压缩感知技术的补偿限幅非线性失真与最小二乘信道估计相组合的新算法,在接收端利用导频数据采用压缩感知算法对限幅失真进行补偿,同时对最小二乘信道估计进行优化运算,以减小噪声对其影响。理论分析和仿真结果均表明,新算法不但能够有效抑制限幅法造成的系统非线性失真问题,而且能够降低高斯白噪声对于信道估计的影响。     

液体中光击穿所激发声场的理论研究

以液体中光击穿所激发声场为研究对象,在等离子体椭球模型的基础上,为方便理论计算,简化等离子体椭球模型,提出了等离子体椭圆盘模型,对光击穿所激发声场进行了理论研究.得到了等离子体椭圆盘辐射声场的声压规律,并利用椭圆坐标变换,依据马修函数特性和模态的正交性,求得了等离子体椭圆盘振动位移的解析表达式.     

基于超声波干涉的峰谷法计算声速值及实验误差探讨

介绍了基于Cassy Lab软件下的超声波干涉实验,提出了利用超声波干涉现象测量声速的方法.根据干涉理论推导了峰谷法测量声速的计算公式.分析和探讨了峰谷法计算声速的误差来源和改进方法.     

Experimental assessment of a multicarrier underwater acoustic communication system

This paper presents a multicarrier communication system which transmits information on independent subcarriers to achieve an increased data rate. For this system, a passive-phase conjugation (PPC) based receiver structure is assessed by processing data collected in sea trials. Based on temporal diversity (pulse compression) exploited by PPC processing, an adaptive multichannel decision feedback equalizer is used to remove intersymbol interference, where spatial diversity is exploited by adaptive multichannel combination. The digital phase-locked loop (DPLL) technique is implemented for carrier-phase tracking. In the scenario of low input signal-to-noise ratios (SNRs), the receiver structure achieved superior performance using a common DPLL. In a depth-fluctuated environment, two sea experiments were conducted over ranges of 2 km and 4 km, respectively, and this communication system was assessed with a data rate of 4 kbps. In terms of mean square error, output SNR and bit error rate, this receiver structure has demonstrated its performance for the multicarrier communication system.     

Potential solutions to improved sound performance of volume based lightweight multi-storey timber buildings

Lightweight building systems in general suffer from poor sound insulation, especially in the low frequency region. Since no reliable mathematical models that can predict the impact sound pressure level exists, the lightweight building design is to a high extent based upon previous experience and upon measurements. A special difficulty is related to experimental measurements since the variation among identical units must not be neglected. A modern volume based lightweight wooden building concept has here been tested by numerous well controlled measurements, in laboratory as well as in more field like conditions. The volume construction technique offers new possibilities and challenges to improve sound insulation in light weight timber construction. The main purpose was to investigate how different constructional solutions in the floor, like plaster board, mineral wool, elastic glue, dividing board, floating floor etc., affect the sound insulation. Many of the tested modifications resulted in only marginally changed impact sound pressure level but parameters that substantially can improve the sound insulation were found in using elastic glue to mount the floor boards, to install extra board layers and to use floating floors.     

Efficient anti-stokes signal generation through degenerate four wave mixing in an all solid photonic bandgap fiber

We reported the generation of visible red light through degenerate four wave mixing (FWM) in an all solid photonic bandgap fiber (PBGF), which was achieved by pumping the fiber with a 800 nm Ti:sapphire-based femtosecond pulse laser. At a fiber length of 30 m, a broadband anti-Stokes spectrum range from 620 nm to 740 nm was obtained at the highest pump power, the spectrum evolution as a function of pump power and propagation distance had been measured. Furthermore, the intensity-dependent parametric gain characteristic is also calculated, which accords well with the experimental results.     

Effects of the piezoelectric field on the modulation of exciton–polaritons by surface acoustic waves

Surface acoustic waves (SAWs) provide a powerful tool for the modulation of polaritons in GaAs-based microcavities. In this contribution, we compare the modulation introduced by SAWs propagating along piezoelectric and non-piezoelectric crystal directions of the sample surface. Strain calculations reveal that the type-I band-gap modulation induced by the strain field is comparable for both SAW types. Piezoelectric SAWs have, however, an intrinsic longitudinal electric field, which can dissociate quantum well (QW) excitons and, thus, degrade the modulation. Images of the polariton far-field photoluminescence reveal this behavior for different excitation conditions.     

全息声压场的加权范数外推方法

全息声压外推是Patch近场声全息技术的关键步骤.本文提出了全息声压的加权范数外推方法,该方法首先通过实测声压数据的功率谱信息构造频域加权范数,然后通过极小化频域加权范数实现全息声压外推.由于外推过程中同时利用了声压信号的波数域带宽和波数谱形状信息,因此其外推结果优于传统带限外推方法.数值仿真结果表明,该方法无论在外推精度还是计算效率上都明显优于经典的全息声压波数域外推方法.刚性箱体上的声激励固支板声压外推实验进一步验证了该方法的有效性和实用性. 关键词： 近场声全息 全息声压外推 加权范数     

界面条件下线型超声相控阵声场特性研究

开展了界面条件下线型超声相控阵声场特性的研究.将带有楔块的超声相控阵问题合理简化为液固界面的情况进行讨论.根据射线声学理论,计算了单阵元在液固界面存在时的辐射声场,进而推导了聚焦法则,得到了超声线型阵在液固界面存在时的声场、位移场表达式.对安装在楔块上的相控阵换能器的辐射声场进行了仿真,并讨论了聚焦对换能器轴向和横向声场的影响,结果表明利用聚焦能提高分辨率和灵敏度,但聚焦区域之外声束性能更差,在实际检测中要合理利用聚焦. 关键词： 超声相控阵 界面 声场 聚焦